Tel : 0086 13663713257
E-mail : admin@rothmancompressor.com
Oil-air separator is the screw lubricating oil and compressed air separation components, under normal operation, the service life of the oil-air separator in the 3000 hours or so, but the quality of lubricating oil and air filtration precision has a huge impact on its life. It can be seen in the harsh use of the environment must shorten the maintenance and replacement cycle of the air filter element, and even consider adding the front air filter. The oil-air separator must be replaced when it expires or when the pressure difference between front and rear exceeds 0.12Mpa. Otherwise, it will cause motor overload, oil and gas separator breakage oil.
1. Remove the control fittings installed on the cover of the oil and gas tank. Take out the oil return pipe that extends into the oil and gas drum on the cover of the oil and gas drum, and remove the fastening bolts on the cover of the oil and gas drum.
2. Remove the upper cover of the oil and gas drum and take out the oil and gas separator. Remove the asbestos gasket and dirt stuck on the upper cover.
3、Fit the new oil-air separator, note that the upper and lower asbestos gaskets must be stapled, and the asbestos gaskets must be placed neatly when pressed, otherwise it will cause the gasket to be washed out.
4、Fit back the upper cover plate, oil return pipe, each control pipe as it is, and check whether there is any
You may Like:
If you are interested in atlas copco air compressor, please contact us
email: admin@rothmancompressor.com or send your inquiry in the form below.we will reply you within 24 hours.
©2020 atlas copco air compressor