Tel : 0086 13663713257
E-mail : admin@rothmancompressor.com
Tel : 0086 13663713257
E-mail : admin@rothmancompressor.com
When we choose to buy an air compressor the salesperson usually asks us about the pressure, flow rate, technical other specification parameters of the gas and...
Details >1、Before daily or each operation.
(1) Drain the oil and gas tank
(2) Check the oil level
(3) Peripheral equipment preparation, such as sending water and elect...
Daily maintenance of air compressors is essential to their safe and stable operation and to extend their service life. High exhaust gas temperature is a problem...
Details >When the filter is blocked, the differential pressure switch will close and send out an alarm signal to avoid the filter being too dirty to reduce the air quali...
Details >Air compressor in normal operation, although the air compressor will send air to the storage tank, but is the pressure expressed less than the normal pressure v...
Details >In the refrigeration system of the cold dryer, the change of condensate high pressure is adjusted by controlling the opening of the water flow control valve of...
Details >Under the condition of keeping the compressed air pressure basically unchanged, reducing the temperature of the compressed air can reduce the water vapor co...
Details >Reseating pressure refers to the static pressure at the inlet of the valve after the safety valve reaches the discharge state, that is, when the opening h...
Details >In general, we may all think that selecting the filter with corresponding processing accuracy according to the required air quality can meet the requireme...
Details >1. The lubricating oil in the air compressor body needs to be replaced
2. Check the surface friction of the piston rod of the air compressor for wear marks and...
The working principle of the centrifugal air compressor is that after the air enters the impeller of the air compressor, under the action of the impeller bl...
Details >1. It is forbidden that the lubricating oil temperature is lower than 68 ℃ during the operation of the air compressor;2. The operating oil temperature of lubri...
Details >1. If the vibration is too large, it will accelerate the wear of the bottom and contact surface of the air compressor, and wear will occur after a long time; 2...
Details >1. Check the lubricating oil cooling system for blockage and leakage. Because the blockage of the cooler will cause the temperature of the lubricating oil to r...
Details >1. The permanent magnet variable frequency air compressor adopts the latest generation of integrated direct connection structure, which is more stable and energ...
Details >Air leakage of air compressor can generally be divided into internal leakage and external leakage. Internal leakage refers to the leakage of gas from high pres...
Details >Generally, when the air compressor runs for 2000 hours, the lubricating oil of the air compressor needs to be replaced. The correct oil change procedure is as f...
Details >In order to ensure the normal operation of the air compressor and its rear equipment, in addition to regular maintenance (replacing consumables), daily spot in...
Details >1. Oil level too high: check whether the oil level is discharged between "H" and "L".
2. Check the spring fatigue of pressure maintenance valve: replace the sp...
Atlas Copco sells a variety of products in China and carries out corresponding service and market development business. These products include air and gas comp...
Details >Failure phenomenon of screw air compressor: low unit pressureThe reason for this fault is that the actual gas consumption is greater than the output gas of the...
Details >What is the reason for the insufficient cooling capacity of the air compressor?...
Details >1. The cooler shall be dust cleaned at least once a week.2. The air filter needs to be removed for dust removal after working every day.3. Check whether there i...
Details >1. The pressure shall not be too large, and the range shall not exceed the maximum pressure value marked on the filter2. In order to prevent backflow and impact...
Details >What are the causes of ultra-high exhaust temperature (ultra-high 100 ℃)?The unit coolant level is too low (it should be visible from the oil sight glass at t...
Details >
©2020 atlas copco air compressor.
